Loading ...
Loading ...
Loading ...
12
Hood installation on ceiling (page 7)
• Remove the Styrofoam protective piece before use.
• The accessories needed for installation are inside the hood.
• Use the two screws to attach the reducer pipe H to the upper platen
(Fig. 1). Connect the 6” non-flammable pipe to the opening in the ceiling.
• Confirm that the ceiling will support the weight of the hood. Drill 4 holes in
the ceiling using a 5/6” bit and insert the plugs (Fig. 2).
• Adjust the length of the telescopic structure and attach the two pieces with
8 screws and washers. Bear in mind that the minimum distance from
working surface to the base of the hood should not be less than 25” (Fig.
3).
• Attach the previously adjusted telescopic structure to the ceiling using 4
screws and washers (Fig. 4).
• Introduce pipe J with the grate on the upper part and attach the telescopic
structure using 2 screws (Fig. 4).
• Introduce pipe K and keep it raised (Fig. 5).
• Affix the hood to the telescopic structure using the nuts and washers (Fig.
5).
• Lower pipe K and attach it to the hood with 2 screws (Fig. 5)
Connecting the hood to the grid
Warning: Before connecting the hood: Switch off the electricity supply
and check that the supplied voltage and frequency coincide with that
indicated on the appliance nameplate.
Connect the hood directly to the electrical grid, protected by a separator
device accessible for disconnection, in line with local regulations.
Loading ...
Loading ...
Loading ...