Loading ...
Loading ...
Loading ...
User instructions
16
INTERRUPTING
A
PROGRAM
In order to interrupt a running program it is necessary:
• to press the START/PAUSE for some seconds until when the
led START/PAUSE remains lit on (confirmation beep). At this point,
it is possible to start the cycle again, otherwise:
•
TO CH
ANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “INTERRUPTING A PROGRAM”);
• select the new program;
• to press again the START/PAUSE button to make start the
new program.
STOPPING A PROGRAM
To cancel a program which is running:
• Interrupt the program (see "INTERRUPTING A PROGRAM")
• Press the START/PAUSE button and hold it down; the
display will show "P0" and the dishwasher will immediately
switch to the end of the cycle and drain the tank (during this
process, the "START/PAUSE led will flash). When the drain
procedure ends, the end of cycle "End" message appears on
the display.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TARTING THE PROGRAM”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 60 seconds later.
Loading ...
Loading ...
Loading ...