Changing the condensation drain
The condensation from the dryer can either be discharged into the condensate container or led away
via a connection to the waste water system. The method installed at the factory is that the condensation
from the dryer is discharged into the condensate container. If the condensate drain is installed a rest
amount of water remains in the condensate container due to the self cleaning function. To change the
method of draining the condensation, you can take the following steps:
Remove the accessories from the dryer drum.
When the dryer is delivered direct from the
factory, the hose for discharging the
condensation into the condensate container is
fastened to the adapter.
Disconnect the hose from the adapter (a) and
place it in the 'parked' position on the hose clip (b).
Then remove the drain hose from the
accessory and fasten it to the empty adapter (a).
Depending on how you connect the hose (A, B or C), fit the drain hose with the remaining accessories.
Check the dimensions.
Do not plug the drain of the wash basin and check that the water can flow away quickly. Blocked water
can be drawn back into the dryer and cause damage.
To prevent leaks or water damage, secure the drain hose against slipping out of position. Do not kink
the drain hose. The difference in height between the installation surface and the drain should not
exceed 100 cm. The minimum height for a drain in a siphon is 80 cm.
1
2
a
b
a
3
$
%
&
$
&
min. 80 cm
max. 100 cm
Loading ...
