Loading ...
Loading ...
Loading ...
en-US
20
Open the dust compartment lid.
Lift the exhaust filter and remove it.
Insert a new exhaust filter, making
sure it goes in properly, then push it
down into position.
If you are using exhaust filter c or d,
press the TimeStrip® exhaust filter
change indicator (Fig. 12).
After approx. 10–15 seconds, a thin red
line will appear in the left hand side of
the display for both exhaust filters (Fig.
13).
If you wish to fit the AirClean exhaust
filter, see "Replacing one type of ex-
haust filter with another".
Close the dust compartment lid.
Replacing one type of exhaust filter
with another (Fig. 09)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b AirClean Plus 50 (light blue)
c Active AirClean 50 (black)
d HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter please note
1. If you wish to replace exhaust filter a
with filter b, c, or d, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
If you are using exhaust filter c or d,
you must also activate the
TimeStrip® exhaust filter change in-
dicator (Fig. 12).
2. If you wish to replace exhaust filter b,
c, or d with filter a, it is essential that
you also fit the filter grille * (Fig. 31).
* Filter grille – see "Optional acces-
sories"
When to change the thread catchers?
(only possible for models with a re-
versible floorhead included as standard)
The thread catchers on the suction inlet
of the reversible floorhead can be re-
placed. Check them from time to time
and replace them if the pile has worn
down.
How to replace the thread lifters
(Fig. 34 + 35)
Use a suitable screwdriver to remove
the thread lifters from the slots.
Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (Fig. 36)
Clean the roller on the floorhead if re-
quired.
Release the bearing using a coin.
Press the bearing out, and remove.
Remove the roller.
Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele dealer or through Miele
Technical Service.
Loading ...
Loading ...
Loading ...