Loading ...
Loading ...
Loading ...
en-us
16
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice even if the appliance is still under guarantee!
Fault Possible cause Remedial action
Temperature differs greatly
from the set value.
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
The light does not work. Light switch is jammed. Check whether the light switch can move.
The light is defective. (See chapter “Light”.)
Controls have reduced lumi-
nosity.
When the appliance is not used for
some time, the display on the fascia
switches to energy saving mode.
As soon as the appliance is again used, e.g. the
door is opened, the display switches back to nor-
mal illumination.
Displays do not illuminate. Power failure;
the fuse has been switched off;
the mains plug has not been
inserted properly.
Connect mains plug. Check whether the power
is on, check the fuses.
The temperature in
the freezer compartment is
too warm.
Appliance opened frequently. Do not open the appliance unnecessarily.
The ventilation openings have been
covered.
Remove obstacles.
Large quantities of fresh food are
being frozen.
Do not exceed max. freezing capacity.
Freezer compartment door
was open for a long time;
temperature is no longer
reached.
The evaporator (refrigeration gener-
ator) in the No Frost system is cov-
ered in thick ice and can no longer
be defrosted fully automatically.
To defrost the evaporator, remove the frozen
food with the compartments, insulate well and
store in a cool location.
Switch off the appliance and move it away from
the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins to
run into the evaporation pan, at the rear of the
appliance.
To prevent the evaporation pan from overflowing
in this case, mop up the condensation with
a sponge.
The evaporator is defrosted when the water
stops running into the evaporation pan. Clean
the interior. Switch the appliance back on again.
Loading ...
Loading ...
Loading ...