Loading ...
Loading ...
Loading ...
MOBILE HOME INSTALLATION
I. Dryer MUST be exhausted outside (outdoors, not beneath
the mobile home) using metal ducting that will not support
combustion. Metal ducting must be 4 inches (10.16 cm) in
diameter with no obstructions. Rigid metal duct is preferred.
2. If dryer isexhausted through the floor and area beneath the
mobile home isenclosed,the exhaustsystemMUSTterminate
outside the enclosure with the termination securelyfastened
to the mobile home structure.
3. When installing a gas dryer into a mobile home, a provision
must be made for outside make up air.This provision isto be
not lessthan twice the area of the dryer exhaust outlet.
4. This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No. 346764 isavailable from your dealer.
5. Refer to pages 2 and 3 for other important venting
requirements.
6. Installation MUSTconform to current Manufactured Home
Construction & SafetyStandard (which isa FederalRegulation
Title 24 CFR-Part 32-80) or when such standard is not
applicable, with American National Standard for Mobile
Homes.
The dryer is designed under
ANSI Z 21,5,1 or ANSI/UL2158- CAN/CSA
C22.2 (latest editions) for HOME USEonly.
DO
UNPACKING
Using the four shipping carton corner posts (two on each
side), carefully lay the dryer on its left side and remove the
foam shipping base.
Toprevent damage, do not usethe control
panel as a means to pick up or move the dryer.
2. Return the dryer to an upright position.
_) FOAM
SHIPPING
PAD
Correct
i l ii
ill _ i
©
!iii_iiiiiil
i_ii!iiii!i!i
Incorrect
7
Loading ...
Loading ...
Loading ...