Loading ...
Loading ...
Loading ...
INTERMITTENT WIPER SYSTEM
Use the intermittent wiper system when weather con-
ditions make a single wiping cycle, with a variable pause
between cycles, desirable. Rotate the end of the wind-
shield wiper/washer control lever to one of the first
five detents to select the desired delay interval
(fig. 67)
There are five delay settings, which allow you to regulate
the wipe interval from a minimum of one cycle ever y two
seconds to a maximum of approximately 36 seconds
between cycles at vehicle speeds below 16 km/h. At
speeds greater than 16 km/h, the delay varies from a
minimum of one cycle every second to a maximum of
approximately 18 seconds between cycles.
NOTE: The wiper delay times depend on vehicle
speed. If the vehicle is moving less than 16 km/h, delay
times will be doubled.
WINDSHIELD WIPER OPERATION
Rotate the end of the lever upward, to the first detent
past the intermittent settings for low-speed wiper
operation. Rotate the end of the lever upward to the
second detent past the intermittent settings for high-
speed wiper operation.
(fig. 68)
NOTE: The wipers will automatically return to the
“park” position if you turn OFF the ignition switch
while they are operating. The wipers will resume op-
eration when you turn the ignition switch back to the
ON position.
(fig. 67)
Front Wiper Control
(fig. 68)
Front Wiper Control
92
KNOWING
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
W
ARNING
LIGHTS
AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Loading ...
Loading ...
Loading ...