Loading ...
Loading ...
Loading ...
5
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions
www.GEAppliances.com
When the air conditioner is turned on, it will
automatically start in the setting last used,
except the timer will be cancelled if it was set.
Lights on the air conditioner control panel indicate
the selected settings.
Use the COOL mode with HIGH (F3), MED (F2) or LOW
(F1) fan for cooling. Use the Increase ▲ / Decrease
▼ pads to set the desired temperature between
60°F and 86°F in 1°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while
set to COOL, it will take approximately 3 minutes for the
compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the COOL mode and
HIGH (F3), MED (F2) or LOW (F1) fan with a middle set
temperature.
For Maximum Cooling—Select the COOL mode and
HIGH (F3) fan with a lower set temperature.
For Quieter & Nighttime Cooling—Select the COOL
mode and LOW (F1) fan with a middle set
temperature.
COOL Mode
Use the FAN at HIGH (F3), MED (F2) or LOW (F1) to
provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
FAN Mode
Fingertip pressure on the horizontal louvers
adjusts the air direction up or down.
Air Direction – Up and Down
The side-to-side air direction is adjusted by moving
the lever to the left or right.
Air Direction – Side-to-Side
DEHUM Mode—Dehumidification
Use the DEHUM mode to provide dehumidification
only. The fan will run at a fixed speed at this setting,
so a fan speed cannot be set. Keep windows and
doors closed for the best dehumidifying effects.
• Press the MODE pad until the DEHUM indicator
light is lit.
In the DEHUM mode, a set temperature will not be
displayed.
Loading ...
Loading ...
Loading ...