User Manual Bosch SHS63VL2UC 24" Scoop Handle Dishwasher

• Owner's manual - (English)

• Energy Guide - (English)
• Installation Instruction - (English)
• Produc Spec Sheet - (English)

Dishwasher User Manual Bosch model SHS63VL2UC 

Table Of Contents

• Safety Definitions
• IMPORTANT SAFETY
• INSTRUCTIONS
• Causes of Damage
• Getting Started
• Rinse Aid
• Loading the Dishwasher
• Detergent
• Dishwasher Cycles
• Dishwasher Cycle Options
• Operating the Dishwasher
• Care and Maintenance
• Troubleshooting
• Customer Service
• Statement of Limited
• Product Warranty

Adding rinse aid

• To avoid oversudsing or clogging, do not overfill the rinse aid dispenser 9". Wipe up any spills with a damp cloth.
• Open the rinse aid dispenser 9" by pressing on the latch of the lid and pull it open.
• Add liquid rinse aid to the dispenser 9" until it is full. Do not overfill.
• Close the lid. Lid must be fully closed until it clicks in order to seal.
• Wipe up any excess rinse aid that may have puddled when the dispenser reservoir is full.
• The indicator light will go out a few moments after the dishwasher door is shut.

NOTICE

• Do not fill the rinse aid dispenser 9" with detergent. Doing so will damage the dishwasher.
• Setting the amount of rinse aid used
• The amount of rinse aid dispensed can be set from §:‹‹ to §:‹‡. The factory setting is §:‹†.
• You should only change the setting if streaks remain on the dishes (lower the amount), or if dishes are not getting dry enough (increase the amount).

Note: The dishwasher indicates low rinse aid by turning on the Rinse Aid indicator on the display 8. If this indicator lights up, you need to refill the rinse aid dispenser 9" by following the directions below.