Loading ...
2 3
ASSEMBLY STEPS
STEP 1
Loosen knobs on laptop holder (A) to extend arms.
STEP 3
Attach assembled laptop holder to
75mm and 100mm holes on VESA
mount using M4x6 bolts (E) with
washers (F). Insert fastening straps
(G) through loops underneath the
laptop holder, then pull straight end
of each strap through the loop on the
other end of the strap. Ensure both
straps have the so side facing up.
STEP 4
Place laptop on laptop holder and evenly adjust
both arms to fit to laptop. Tighten the knobs to
lock arm length.
PACKAGE CONTENTS
TOOLS NEEDED
8.8lbs
(4kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING!
Phillips
Screwdriver
A (x1)
Laptop
Holder
B (x2)
Corner Support
C (x2)
Pad
D (x6)
M4x9.5 Screw
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3
YEARS. ADULT SUPERVISION IS REQUIRED.
STEP 2
Mount corner supports (B) to ends of arms on laptop
holder (A) using M4x9.5 screws (D). Apply one pad
(C) to each corner support as shown.
E (x4)
M4x6
F (x4)
Washer
G (x2)
Fastening Strap
STEP 5
Secure laptop using fastening straps.
A
D
B
C
G
F
E
G
Loading ...