Loading ...
Loading ...
Loading ...
Fold back the backrest
Without a cargo position:
1. Pull the strap.
2. Fold the rear seat backrest rearward.
With a cargo position:
1.
Pull the strap.
2. Fold the rear seat backrest rearward. The
rear seat backrest first engages in the load‐
ing position.
3. Pull the strap again.
4. Fold rear seat backrest all the way back.
5. Latch the rear seat backrest.
Variable cargo area
floor
With the variable cargo area floor, the cargo
area can be configured corresponding to trans‐
port requirements. To do this, remove the
cargo area floor, and insert it in the desired po‐
sition.
Follow instructions on securing cargo, refer to
page 170.
Removing the cargo floor panel
1. Fold down the rear seat backrest, refer to
page 172.
2. Fold the rear part of the cargo floor panel
upward.
3. Grasp the cargo floor panel in the rear and
fold up above the locking point of the up‐
per position, refer to page 174.
4. Pull the cargo floor panel backward from
the brackets.
Inserting the cargo floor panel
1.
Push the cargo area floor into the supports
at a shallow angle. The cargo area floor
must engage noticeably.
2. Fold the cargo area floor over downward.
Fold up the cargo floor panel
WARNING
Improper use of the variable cargo floor
panel can lead to a danger of objects flying
about during braking and evasive maneuvers.
Seite 174
CONTROLS
Cargo area
174
Online Edition for Part no. 01 40 2 976 603 - X/16
Loading ...
Loading ...
Loading ...