Loading ...
Loading ...
Loading ...
Using the Steam Cycles
Add Water
Before using a Steam Cycle, the water tank
must be filled with water up to the MAX line.
If not, the ADD WATER light will blink. Make
sure that the water tank is filled with water
and the cartridge is completely connected.
Turn the dryer off and then restart the Steam
Cycle.
1. Turn the dryer off by pressing the POWER
button.
2. Open the lid.
3. Move the lever to open.
4. Lift out the water tank and open the tank
lid.
5. Fill the tank to the MAX water line with
water.
6. Place the water tank back into the barrel
and move the lever to close.
7. Close the lid, press the POWER button and
select the cycles desired.
NOTES
• Only use water. Do not fill the water tank
with foreign substances, rinse agents, or
detergents.
• Before moving the dryer, make sure the
water tank is empty.
• Do not use distilled water; the water level
sensor in the steam generator will not work.
• Be careful while filling the water tank to
avoid overflow and spilling.
• Wipe up any spilled water around the water
tank and the drawer before starting the
dryer.
Screw
Dryer Features. GEAppliances.com
11
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
Installation
Instructions
Changing the Drum Lamp
Before replacing the drum lamp, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the
circuit breaker.
The drum lamp is located at the top left of
the door frame.
1 Remove the screw holding the drum lamp
shield in place.
2 Slide the shield up and remove.
3 Remove the bulb and replace with a
15-watt, 120-volt candelabra-base bulb.
4 Replace the lamp shield and screw.
Using the Drying Rack
A handy drying rack may be used for drying
delicate items such as washable sweaters.
Hook the rack over the lint filter so the rack
extends into the dryer drum.
NOTE:
• The drying rack should only be used with
the TIME DRY cycle. It is also strongly
recommended when drying sneakers.
• Do not use this drying rack when there are
other clothes in the dryer.
Water
ONLY
Water
tank
Duct Sensing
The duct blockage system automatically
monitors, detects and alerts you to blockages
in the ductwork. Blocked ductwork can
degrade dryer performance by reducing
airflow from the dryer. If you observe the
display window with the message, “CLg” it is
time to clean your exhaust ducting in order to
increase efficiency and reduce dry times.
Loading ...
Loading ...
Loading ...