Loading ...
Loading ...
Loading ...
21
COMPLETE INSTALLATION CHECKLIST
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Check dryer’s nal location. Be sure vent is not crushed
or kinked.
q
Check that dryer is level. See “Level Dryer.”
q
Remove lm on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
q
Read “Dryer Use” in your “Quick Reference Guide.”
Electric Models:
q
For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on Power.
Gas Models:
q
Check that gas supply is on.
q
Check for leaks.
Steam Models Only:
q
Be sure the water faucets are on.
q
Check for leaks around “Y” connector, faucet, and hoses.
q
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
All Models:
q
Select a Timed Dry heated cycle, and start dryer. Do not
select Air Only Temperature setting.
If dryer will not start, check the following:
• Controls are set in a running or “ON” position.
• Start button has been pushed rmly.
• Dryer is plugged into an outlet and/or electrical supply is
connected.
• Household fuse is intact and tight, or circuit breaker has
not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its rst cycle.
If your dryer heater is not turning on, then you might have power
supply problem in your house. You will receive L2 code for this
problem. “See Troubleshooting.”
If your Airow screen reads “Check Vent”, your dryer vent may be
crushed or blocked. See “Troubleshooting.”
NOTE: You may notice an odor when dryer is rst heated. This
odor is common when heating element is rst used. The odor will
go away.
DRYER DOOR (ON SOME MODELS)
For normal dryer use, it is not suggested to remove the dryer
door. However, if removal is necessary, make sure the dryer is off
and cool. Then, follow these instructions. The dryer door is heavy.
To Remove:
1. Open dryer door all the way.
2. Use at head screw drive to open hinge latch.
3. Pinch the hinge latch between two ngers and pull forward.
Repeat on other side of dryer door.
A
4. Close the dryer door as far as it will shut.
5. Lift the dryer door while holding both sides.
Continue to push the dryer door closed and pull it away from
the dryer door frame.
1
2
To Replace:
1. Insert both hanger arms into the front panel.
2. Open the dryer door.
You should hear a “click” as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.
A. Hinge latch
Loading ...
Loading ...
Loading ...