Loading ...
Loading ...
Loading ...
8
UNPACKING YOUR FREEZER
1. Remove all packaging material. This includes the foam base and all adhesive tape holding the
freezer accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before powering on the
freezer.
ADJUSTING YOUR FREEZER
• Your freezer is designed for freestanding installation only. It should not be recessed or built-in.
• Place the freezer on a surface strong enough to support it when fully loaded.
• When moving the freezer, never tilt it more than a 45-degree angle. This could damage the
compressor and the sealed system.
• If the freezer is tilted let it stand in an upright position for at least 24 hours prior to plugging in.
This is to allow the refrigerant to settle.
PROPER AIR CIRCULATION
• To assure your freezer works at the maximum effciency it was designed for, you should install it in a
location where there is proper air circulation, plumbing and electrical connections.
• Recommended clearances around the freezer:
Sides……………4” (102mm)
Sides……………4” (102mm)
Top....................4” (102mm)
WARNING:
ELECTRICAL REQUIREMENT - SHOCK HAZARD
ELECTRICAL REQUIREMENT
• Make sure there is a suitable power Outlet (115 volts, 15 amps outlet) with proper grounding to power
the freezer.
• Avoid the use of three plug adapters or cutting off the third grounding in order to
accommodate a two plug outlet. This is a dangerous practice since it provides no effective
grounding for the freezer and may result in shock hazard.
WARNING:
USE OF EXTENSION CORDS- POTENTIAL SAFETY HAZARD
Operating Instructions
Loading ...
Loading ...
Loading ...