Loading ...
Loading ...
Loading ...
Instructions for the installer
28
5.5 Reassembling the hob
Follow the instructions given in paragraph “5.1 Removing the hob ”, but in the reverse
order.
When replacing the burner rings, remember that they have to be tightened
completely by means of the wrench supplied, otherwise the flame interruption zones
on the flame caps will not be aligned with the grid spokes.
When positioning the grids, make sure that the pins are aligned
with their seats in the surface, then press them in with the palm
of your hand until they lock in place.
5.6 Regulation of minimum for natural gas
Replace the components on the burner and slide the
knobs on the gas tap pins.
Light the burner and set it at minimum position
.
Remove the knob and turn the regulation screw inside
or next to the gas tap pin (depending on the model)
until you get a suitable minimum flame.
Replace the knob and check flame stability by rapidly
turning the knob from maximum to minimum. The
flame should not go out.
5.7 Regulation of minimum for LPG
To regulate the minimum for LPG, completely tighten (clockwise) the screw inside or
next to the gas tap pin (depending on the model).
The diameters of the by-passes for each burner are given in table “5.2 Regulation for
LPG ”.
After regulation for a gas other than that inspected, replace the label on the casing
with one for the new gas. The label is inside the bag that contains the nozzles.
*
**
Loading ...
Loading ...
Loading ...