Loading ...
Loading ...
Loading ...
sharkclean.comsharkclean.com
DOCK SETUP
INSTALLING THE SIDE BRUSHES
Snap the 2 included Side Brushes onto the square
pegs on the bottom of the robot.
!
If the robot has no charge and cannot return to
the dock, manually place it on the dock. The dock
indicator light will flash blue and the robot will
beep when charging begins.
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the dock.
If your robot doesn’t return to the dock, its charge
may have run out.
CHARGING
IMPORTANT: The Shark IQ Robot™ has a pre-installed rechargeable battery. Battery should be fully charged
before using. It may take up to 5 hours to fully charge.
To charge, the Power button on the side of the robot
must be in the ON position (I). The robot will beep
when charging begins.
NOTE: When manually placing the robot on the dock, make sure the Charging Contacts on the bottom of the robot are
touching the ones on the dock. While the robot is charging, both blue LED lights will flash. When charging is complete, both
blue lights will illuminate steadily.
NOTE: When picking up the robot, be careful not to place fingers between the bumper and the base of the robot.
NOTE: Select a permanent location for the Charging Dock, because every time you relocate it, your
robot will have to completely re-map your house.
NOTE: For best results, set up on hard floor or thin carpet.
NOTE: Do not place dock against baseboards, heating elements, or in direct sunlight.
5 ft.
3 ft.
3 ft.
Choose a level surface in a central area. Remove any objects that are closer than 3 feet from either side
of the dock, or closer than 5 feet from the front of the dock. Place the dock with its back against the wall.
Connect the Charging Cord to the port on the back of the dock, then plug it into an outlet. The indicator
light on the dock will illuminate green when the dock has power. The dock must be plugged in continuously
for the robot to find it.
Loading ...
Loading ...
Loading ...