Loading ...
Loading ...
Loading ...
8
Electrical Installation
BOSE65M is a 10 amp appliance.
WARNING This apparatus must be earthed.
The oven is only for domestic use.
The feed voltage and the absorbed power are as indicated on the data plate attached to the left-hand side upright,
which can be seen when the oven door is open.
Connecting must be carried out by qualified personnel and in accordance with the regulations currently in force.
The manufacturer cannot be held responsible for any damages to persons or objects caused by failure to observe
these instructions.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
The oven must be connected to the mains through a multiple circuit breaker with a contact-to-contact gap of at least
3 mm, making sure that the earth wire is not disconnected.
For connecting use a flexible cable of the H05V2V2-F 3x1,5 mm2 type remembering to make it long enough to
allow the oven to be removed from its housing unit when maintenance work is required.
To connect the cable to the oven, proceed as follows:
- Remove the lid by unfastening the three screws.
- Unfasten the two screws for the cable holder and feed the cable through the opening immediately below the cover.
- Remove about 12 cm of the outside insulation from the cable and shorten the two active wires (live and neutral) to
6 cm, leaving long the one to be connected to the main earth terminal on the terminal box; remove about 1 cm of
the main insulation from the three wires and connect them correctly to the terminal box, Remembering to respect
the polarities.
- Tighten the two screws of the cable holder and put the lid back on with the three screws.
Electricals Specification
BOSE605X
- Absorbed power:
Grill element: 2200W
Fan forced element: 2300 W
Lamp: 25 W
Hot air fan motor: 20 - 25 W
Cooling fan motor: 25 W
- Maximum absorbed power: (see data plate).
-Supply voltage: (see data plate)
Loading ...
Loading ...
Loading ...