Loading ...
Loading ...
Loading ...
tf oven is used in a new branch drcuit installation
(!996 NEC), mobile home, recreational vehicle, or
where local codes DO NOT permit grounding
through the neutral (white) wire (see figure 3):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance (:able wires.
3. In the circuit breaker, fuse box or junction box:
connect appliance and power supply cable wires as
shown in Figure 3.
Cable from Power Supply
Wires
Ground Wire
(Bare or
Wire)
Black
Wires]
Junction Box U.L.-Listed Conduit
Connector (or CSA listed)
Cable from appliance
Figure 3
4-WIRE GROUNDED JUNCTION BOX
DO NOT ground to a gas supply pipe. DO NOT connect
to electrical power supply until appliance ispermanently
grounded. Connect the ground wire before turning on
tile power (Figure 3).
If connecting to a 4-wire electrical
system (mobile homes), the appliance frame MUST
NOT be connected to the neutral wire of the 4-wire
electrical system.
NOTE TO ELECTRICIAN: The armored cable leads
supplied with tile appliance are UUrecognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than temperature rating of household wiring. The
current carrying capacity of the conductor is governed by
the temperature rating of the insulation around the wire,
rather than tile wire gauge alone.
Heavy Weight Hazard
Use 2 or more people to move and install this
combination oven.
Failure to follow this instruction can result in injury
or damage to the unit.
4. Cabinet Installation
The combination oven can tip when
the door is open. The mounting brackets supplied
with the oven must be attached to the cabinet and
the appliance to prevent tipping of the wail oven
and injury to persons.
Mounting Brackets Installation Instructions
1. Unpack the wall oven. Remove the bottom trim taped
on the oven side panel. Find the 2 mounting brackets
and screws included in the literature package.
2. Install the mounting bracket in the wall cabinet as
shown in Figure 4. Note: To prevent damage to cabinet,
it isrecommended to drill 1/16" (0.16 cm) dia. pilot
holes before installing the mounting brackets.
22 3/16" *
(56.4 cm)
* If wood spacers are needded (seefigure1 ) please
calculate this dimension from the top of the spacer to
the middle of the mounting bracket.
/J
iiii ! iii!ΒΈ
Figure 4
3.Insert the oven into the cabinet opening. Slide oven
inward leaving !_/2" (3.8 cm) clearance between the
oven and front of cabinet (seeFigure 5). Pull the armored
cable through the hole for it in the cabinet and toward
the junction box while moving the appliance inward.
Loading ...
Loading ...
Loading ...