Loading ...
Loading ...
Loading ...
Basic Operation & Riding
82
Riding in Reverse
NOTICE
Your ATV may be equipped with a reverse speed limiter, which helps
the vehicle to maintain a safe speed while riding in reverse gear.
4.
Make sure that the reverse indicator comes on and the gear
position indicator shows “R”.
5.
Release the brakes.
6.
Open the throttle gradually and ride slowly. Do not open the
throttle suddenly or make abrupt turns.
7.
To stop, close the throttle and gradually apply both the front and
rear brakes. Do not abruptly apply the rear brake by itself.
8.
Shift out of reverse and into “N” (neutral) or “1” (1st gear)
• To shift into “N” (neutral), press the upshift switch ( ) (3) once.
• To shift into “1” (1st gear), press and hold the reverse switch
(2), then press the upshift switch ( ) (3) within 10 seconds.
You can also shift into “1” (1st gear) by pressing and holding the upshift
switch ( ) (3), then pressing the reverse switch (2) within 0.5 seconds.
The reverse switch will not operate if you operate continuously with
the reverse switch pressed.
Release the reverse switch once.
The transmission cannot be shifted from neutral back into reverse
when the engine speed is above 3,100 rpm or speed of your ATV is
above 3 mph (5 km/h).
WARNING
3
WARNING
Applying only the rear brake abruptly when
operating in reverse gear could cause the
front wheels to lift off the ground and the
ATV could overturn backwards.
Carefully apply both the front and rear brakes
when stopping in reverse gear.
Loading ...
Loading ...
Loading ...