Loading ...
Loading ...
Loading ...
en Cleaning function
20
.Cleaning function
Cl eani ng functi on
The self-cleaning surfaces in the cooking compartment
are cleaned with the “EcoClean” cleaning function.
The self-cleaning surfaces (back panel, ceiling panel
and side panels) are coated with a porous, matt
ceramic material. This coating absorbs and breaks
down splashes from baking, roasting and grilling while
the oven is in operation. If the surfaces no longer clean
themselves adequately and dark patches appear, the
surfaces can be cleaned by the cleaning function.
Cleaning recommendation
The appliance records how long it is in operation and
which operating mode is used. When cleaning is
recommended, ’– will appear on the display when the
appliance is switched off. You can dismiss this
message by pressing any button except the
A button.
The prompt will continue to be displayed, however, until
the cleaning function has been run in full.
Note: You can completely reset the cleaning
recommendation counter by pressing and holding the
A button for approximately 4 seconds.
The prompt will not reappear until the appliance has
been used a certain number of times again.
Caution!
If you do not act on this cleaning recommendation, the
self-cleaning surfaces in the cooking compartment may
become damaged.
If your appliance is already very dirty, e.g. because you
have used it to cook fatty poultry or roasts, or if you
notice dark patches on the self-cleaning surfaces, do
not delay running the cleaning function until this prompt
appears. The more often or the earlier the appliance is
cleaned, the longer the self-cleaning surfaces will retain
their ability to clean themselves. You can clean the
cooking compartment at any time as required using the
cleaning function.
Note: The counter for the cleaning recommendation
prompt will be reset following a power failure. It is
therefore a good idea to run the cleaning function after
a power failure has occurred.
Before running the cleaning function
Remove shelves, rails, accessories and ovenware from
the cooking compartment.
Cleaning the cooking compartment floor and the
inside of the appliance door
Remove the worst dirt from the cooking compartment
floor, the inside of the appliance door and the interior
lighting. Otherwise, patches will appear that can no
longer be removed.
Caution!
Do not use oven cleaner on the self-cleaning surfaces.
This will damage the surfaces. If oven cleaner does get
onto these surfaces, dab it off immediately using water
and a sponge cloth. Do not rub the surface and do not
use abrasive cleaning aids. ~ "Cleaning" on page 18
:Warning – Risk of burns!
; The appliance becomes very hot on the outside
during the cleaning function. Never touch the appliance
door. Allow the appliance to cool down. Keep children
at a safe distance.
Setting the cleaning function
Make sure you follow all the preparation instructions
before setting the cleaning function.
The cleaning function is preset to run for 1 hour. This
cannot be changed.
1. Use the function selector to set EcoClean p.
The length of the cycle will appear on the display.
2. Use the temperature selector to set the p cleaning
cycle.
The cleaning function will start in a few seconds. The
remaining time will count down on the display.
Ventilate the kitchen while the cleaning function is
running.
An audible signal will sound when the cleaning function
has finished. The time on the display will be zero.
Switch the appliance off by turning the function selector
to the "Off" position.
Delaying the end time
You can delay the end time if required. Before starting,
touch the v button until the "End" symbol is highlighted
on the display. Use the @ button to delay the end time.
The appliance will switch to standby after it is started.
Changing and cancelling
The end time can be changed while the appliance is on
standby.
If you would like to cancel the cleaning function, switch
the appliance off by turning the function selector to the
"Off" position.
Once the cleaning function has finished
Once the cooking compartment has cooled down, wipe
down the cooking compartment with a damp cloth if
necessary.
Note: During operation and while the cleaning function
is active, reddish patches may form on the surfaces.
This is not rust, but residue from food. These spots are
not harmful and do not impair the cleaning ability of the
self-cleaning surfaces.
Loading ...
Loading ...
Loading ...