Loading ...
Loading ...
Loading ...
7
Reverse Doors and Hinges (optional)
IMPORTANT: If you want to reverse your doors so that they
open in the opposite direction, follow these steps. If you are not
reversing the doors, see “Replace Doors and Hinges.”
See complete graphics later in these instructions.
Reverse Center Hinge
1. Remove the three dome caps and screws from the handle
side and use them to ll the holes created when the hinge
screws were removed.
2. Using the three 5⁄16" hex-head hinge screws, removed in
Step 1, insert two screws halfway into the holes, leaving
space to insert the Center Hinge.
3. Once the refrigerator door is in place, slide the center hinge
from the right onto the screws, insert the third screw, and then
tighten all screws completely.
NOTE: Make sure the washers are in place on both the top
and bottom pins of the center hinge.
Reverse Freezer Door
1. Remove the three cabinet hole plugs from the top of the
cabinet and place them in the hinge holes on the opposite
side.
2. Remove the door handles. See the model specic graphics
later in these instructions.
Door Handles installed with at-head screws and
setscrews:
■ Remove the two at-head handle screws from the bottom
of the freezer door handle.
■ Using the 1/8" hex key, loosen the setscrew attaching the
top of the handle.
■ Pull the handle away from the door to release it from the
shoulder screw. Keep all parts together.
Door handles installed with at-head screws only:
■ Remove the screw cover and the three at-head handle
screws. Keep all parts together.
3. Using the plastic tool (provided), remove the brand badge
from the freezer door by prying up the right-hand side and
slowly peeling the badge away from the door, revealing the
hole to mount the door handle.
NOTES:
■ To avoid scratching the nish, do not use a sharp or
metallic object to pry the brand badge from the door.
■ Rub a small amount of liquid dish soap over any adhesive
residue with your ngers. Rinse the door with warm water
and dry with a soft cloth.
4. Depending on your model, remove the shoulder screw and its
washer from the left-hand side of the door and fasten it into
the hole that was behind the brand badge.
5. Remove the door stop from the bottom of the freezer door.
6. Move the door stop to the opposite side making sure that the
hole in the door stop plate is aligned perfectly with the hole
for the center hinge pin.
7. Using the screw removed earlier, fasten the door stop to the
bottom of the freezer door.
Door
Hinge
Hole Plug
Cabinet Hinge
Hole Plug
Dome Cap
Washer
Dome Cap
Setscrew
Shoulder
Screw
Shoulder
Screw Washer
Screw
Door
Stop
Flat-Head
Handle
Screw
Door Handle
Hole Cap
A
B
C
A. Dome cap washers
B. Hex-head hinge screws
C. Dome caps
A
A
B
A. 5⁄16" hex-head hinge screws
B. Washers
A
A. Cabinet hole plugs
AB
A. Door stop screw
B. Door stop
A
A. Door stop screw
Loading ...
Loading ...
Loading ...