Loading ...
Loading ...
Loading ...
5
LOCATION OF PARTS
NOTES: 1. Models with BI in the model number suffix can be installed either built-in or free-standing.
2. Models with CSS in the model number suffix have cabinets fully wrapped in stainless steel.
3. The metal insert for wine cellars allows you to lay 3 Bordeaux bottles or 2 Burgundy bottles
safely on the floor.
4. Shelves for wine cellars are wooden. Those for beverage merchandisers are chrome-
plated wire.
INSTALLATION INSTRUCTIONS
• Remove the exterior and interior packing.
BEFORE USING YOUR APPLIANCE
• CAUTION: After unpacking and before connecting the appliance to the power source, you MUST
allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to
drain back into the compressor and stabilize. Failure to do so may adversely affect performance
and the lifetime of the unit.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the door. (See page 7.)
• Your appliance is designed to be free-standing, but can be built-in (fully recessed) if the model number
includes the letters ”BI”. If free standing, the unit should have at least 4” (102 mm) of clearance at both
sides, at the top and at the back to allow for adequate ventilation. Built-in models do not require any
additional clearance, as they include an exterior collar and rear fan that ensure the unit is properly
ventilated.
INSTALLATION OF YOUR APPLIANCE
• WARNING: Do not store or install the appliance outdoors.
• CAUTION
: This appliance is designed for storing and cooling bottles of wine or other beverages. Do
not store perishable food, medicine or other medical products.
• Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the
Handle
Half
Shelf (Total 1)
Door
Digital Control Panel
Levelling Legs
Security Lock
Interior Light
Full
Shelf (Total 3)
Metal floor insert
for WC2 models
(not shown)
Loading ...
Loading ...
Loading ...