Loading ...
Loading ...
Loading ...
WARNING!
Always close the trunk lid when your vehicle
is unattended. Once in the trunk, young
children may not be able to escape, even if
they entered through the rear seat. If trapped
in the trunk, children can die from suffoca-
tion or heat stroke.
UNIVERSAL GARAGE DOOR OPENER
(HOMELINK)
• HomeLink replaces up to three hand-held
transmitters that operate devices such as ga-
rage door openers, motorized gates, lighting or
home security systems. The HomeLink unit is
powered by your vehicles 12 V olt battery.
• The HomeLink buttons that are located in the
overhead console or sunvisor designate the
three different HomeLink channels.
• To operate HomeLink, push and release any of
the programmed HomeLink buttons. These
buttons will activate the devices they are pro-
grammed to with each press of the corre-
sponding HomeLink button.
• The HomeLink indicator light is located above
the center button.
Before You Begin Programming HomeLink
For efficient programming and accurate trans-
mission of the radio-frequency signal, it is rec-
ommended that a new battery be placed in the
hand-held transmitter of the device that is being
programmed to the HomeLink system. Make
sure your hand-held transmitter is programmed
to activate the device you are trying to program
your HomeLink button to.
Ensure that your vehicle is parked outside of the
garage before you begin programming.
It is recommended that you erase all the chan-
nels of your HomeLink before you use it for the
first time.
If you have any problems, or require assistance,
please call toll-free 1-800-355-3515 or , on the
Internet at HomeLink.com for information or
assistance.
Erasing All The HomeLink Channels
To erase the channels, follow this procedure:
1. Place the ignition switch into the ON/RUN
position.
2. Push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds, or
until the HomeLink indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink for the first time.
Do not erase channels when programming addi-
tional buttons.
HomeLink Buttons And Indicator Light
47
Loading ...
Loading ...
Loading ...