WSF6606W User Manual

Loading ...

FAILURE CODES

FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE

PRACTICAL AND USEFUL INFORMATION

1 Wheneveryouwillnotbeoperatingyourmachine:

• Unplugthemachineandthenturnthewateroff.

• Leavethedoorslightlyajarinordertopreventthe

formationofunpleasantodours.

• Keepthemachineinteriorclean.

2 Eliminatingwaterdroplets:

• Washthedisheswiththeintensiveprogram.

• Increasetherinseaidsetting.

• Ifplasticitemsarewashed,waterdropsonthese

itemswillbeunavoidable.Programswithhigher

temperaturesandincreasedrinseaidsettingsmay

reducethewaterdrops.Checkthattheplastic

itemsaresuitablefordishwasheruse.

3 Correctlyloadeddisheswillgivethebestenergy

consumption,washinganddryingperformance.

4 Cleanallroughwastebeforeyouplacedirtydishesin

themachine.

5 Operatethemachineafteritiscompletelyfull.

6 Usepre-washingprogramonlywhennecessary.

7 Observeprograminformationandaverage

consumptionvaluestablewhenselectingaprogram.

8 Sincethemachinewillreachhightemperatures,it

shouldnotbeinstalledneararefrigerator.

9 Iftheapplianceislocatedinaplacewheretherisk

offreezingexists,youmustcompletelydrainthewater

thathasremainedinthemachine.Turnoffthewater

tap,disconnectthewaterinlethosefromthetapand

allowtheinteriorwatertodrain.

ERROR CODE ERROR DESCRIPTION CONTROL

F5 Inadequatewatersupply

•Makesurethewatertapisopenandthatmainwatersupply

ison.

•Closethewatertap,separatethewaterinlethosefromthetap

andcleanthefilterattheconnectionendofthehose.

•Restartyourmachine,contacttheservicecentreifthe

errorresumes.

F3 Errorofcontinuouswaterinput

•Closethetap.

•Contacttheservicecentre.

F2 Thewastewaterinthemachinecannot

bedischarged

•Waterdrainhoseisclogged.

•Spigotonsinktapisblocked.

•Thefiltersofyourmachinemightbeclogged.

•Poweroffyourmachineandactivatetheprogram

cancellationcommand.

•Checkthedrainspigot’smembranehasbeenremovedor

blocked.

•Iftheerrorcontinues,contacttheservicecentre.

F8 Heatererror •Contacttheservicecentre.

F1 Alarmisactiveagainstwateroverflow

•Poweroffyourmachineandclosethetap.

•Contacttheservice

centre.

FE Faultyelectroniccard •Contacttheservicecentre.

F7 Overheatingerror(temperatureinthe

machineistoohigh)

•Contacttheservicecentre.

F9 FlowControlValvepositionerror •Contacttheservicecentre.

F6 Faultyheatersensor •Contacttheservicecentre.

Loading ...

User Manual - Page 24