Loading ...
Loading ...
Loading ...
Care and maintenance
instructions
Add rinse aid
When the rinse aid needs topping up, the above symbol lights on the
display.
Press to open
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked max.
3. Wipe up any spilled rinse aid around the compartment.
4. Close the lid firmly.
After topping up, it may take a while before the symbol goes out.
Add salt
When the salt needs topping up, the above symbol lights on the display.
Salt compartment lid
When the salt runs out, unscrew the cap and fill the container with salt.
Water is only needed the first time! Wipe clean and tighten. Run a
program to ensure that any salt in the dishwasher is rinsed away.
After topping up, it may take a while before the symbol goes out.
WARNING!
In order to avoid rust stains, a dishwashing program must be started
immediately after adding salt.
Never pour dishwasher detergent into the salt compartment. This
destroys the water softener!
Coarse filter
The coarse filter traps larger food particles, which cannot get past the
drain pump. Empty the coarse filter when necessary.
Coarse filter
1. Lift the coarse filter by the handle.
2. Empty the coarse filter. Remember to reinstall it!
Fine filter
Debris that collects on the fine filter is automatically rinsed away during
each wash. Clean the fine filter when necessary.
Fine filter
1. Turn the handle counterclockwise.
2. Lift the filter straight up using the handle. Remove the coarse filter
to clean the fine filter.
3. Reinstall in reverse order. Check that the edges seal properly when
reinstalling the fine filter.
4. Lock the filter in place by turning the handle clockwise to the stop
position. The handle should point straight out from the dishwasher.
NOTE!
Dishwashing results may be
affected if the filters are incorrectly
fitted. Note that the dishwasher
must not be used without the filters
in place!
NOTE!
Check that the colored stop on the
right in the bottom drain is in
place.
Spray arms
Holes and bearings can become blocked. Remove debris using a
needle or similar item. The spray arms have holes on the bottom.
Spray arms can be removed for cleaning. Remember to fit them firmly
back into place afterward.
Top spray arm
• Remove the upper basket then release the top spray arm. See
section Upper spray arm.
• Pull out the top cutlery tray. Push the top spray arm up and turn the
spray arm bearings counterclockwise to remove the spray arm.
15
Loading ...
Loading ...
Loading ...