Loading ...
Warning: Before assembly of this kit read through the
complete assembly instructions step by step and note
all cautions
• Do not install the light in a damp, wet or
outdoor location.
• Do not pick up the light using the horizontal arm.
Always use the vertical arm to carry the light.
• Never position the light by moving the weight.
Always use the horizontal arm holding the LEDs.
• Do not look directly into the light source.
• Do not interfere with the flat power cable visible in
the vertical and horizontal arms of the light. This is
an electrical conductor and key component of the
product.
• Always use the power supply provided.
Do not re-wire.
• The product is not compatible with dimmer circuits.
• The LEDs are non - replaceable – if damaged or
faulty, please contact Jake Dyson Light or your
nearest retailer.
• Only clean with a microfibre cloth.
Warranty: This product has a limited 2 year
warranty covering reasonable use of the product. If a
component fails within the 2 year warranty period, it
will be replaced, subject to inspection.
WARNING: This product contains chemicals
known to the State of California to cause cancer,
birth defects or other reproductive harm.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
IMPORTANT SAFETY INSTRUCTIONS
interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
EN
30.03.2017 15:39 - C87122_CSYS-C_OPMAN_GLOB_JDL-CLAMP-87122.indd_15_4c0s
Loading ...
Loading ...
Loading ...