Loading ...
Loading ...
Loading ...
Adjusting Your Oven Temperature
Your new oven has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow
your recipe times and temperature recommendations carefully. If you feel your oven is too hot or too cool from your baking
experience, the oven temperature may be adjusted to your liking, see instructions below.
Note: DO NOT adjust your oven temperature based on oven thermometers, such as those found in grocery stores because
they may not be accurate.
To Adjust the Oven Temperature (do not use Bake or Broil while adjusting the oven temperature):
.
Press & hold the key pad and release after the display shows the factory temperature setting of 00.
Note: If the oven temperature has been previously adjusted from the factory setting, the current temperature adjusted
value will appear in the display instead.
2. You may increase the oven temperature in 5°F increments with each press of the/k key pad to a maximum oven
adjustment of +35°F. You may also adjust the oven temperature downward in 5°F increments with each press of the v
key pad (tota! range of -35 to +35 ). Note: Your oven control was factory set in the (Fahrenheit) ° F Temperature Display
Mode. To change for (Celsius) °C, see Changing the Temperature Display Mode inthe Oven Control Functions section
of this Use & Care Manual.
3. If no other key pad is pressed after 5 seconds the display will begin to flash.
4. If you do not want to keep the display adjustment, press the _"_ key pad before the oven control beeps. This will cancel
the temperature adjustment procedure. To start this procedure over again begin with step 1 above OR;
5. If you want to keep the adjustment, wait until the display quits flashing and the oven control beeps once.
6. The oven temperature adjustment has be accepted by the oven control and the display will return to the time of day. _,
Notes: The oven temperature adjustment may be made if your oven control has been set to operate in the (Celsius) °C ........
Temperature Display Mode. In this case each press of the A orv key will adjust in 1°C increments upward (maximum _i_
+18°C) or downward (maximum -18°C), depending on which arrow key pad is pressed.
Failure Modes
All failure modes give a visual and audible alarm. When display shows F10 (internal fault), F30=F31 (oven sensor circuit fault)
other F error codes, the electronic oven control has detected a fault condition. Note that code and push the _
or
any
pad
to clean the display and stop the beeping. Reprogram the oven. If fault recurs, push _ pad, disconnect the appliance to
prevent damage and contact an authorized servicer.
13
Loading ...
Loading ...
Loading ...