Loading ...
Loading ...
TROUBLESHOOTING
WARNING: DC 12V OUTPUT SOCKET CURRENT OUTPUT, DO NOT EXCEED 10 AMP.
STARTING AID FOR MOTOR VEHICLES
- The jumper cable terminals are located at the back of the PowerTank. (Fig. 23)
- Use the PowerTank as a source of a starting aid only when the vehicle battery is partially
discharged.
- The PowerTank is not suitable for starting a vehicle with a fully discharged battery!
- Use only jumper cables of sufficient size (cross section).
HOW TO USE THE POWER TANK TO START A VEHICLE:
- The ON/OFF switch can be set to “ON” or “OFF” position for the starting aid function.
- Connect the POSITIVE pole (+) of the PowerTank to the POSITIVE pole (+) of the vehicle
battery.
- Connect the NEGATIVE pole (-) of the PowerTank to the NEGATIVE pole (-) of the vehicle
battery.
- Leave the PowerTank connected to the vehicle battery for about 20 minutes.
- After approximately 20 minutes, disconnect the jumper cable from the NEGATIVE pole (-) of the vehicle battery.
- Disconnect the jumper cable from the POSITIVE pole (+) of the vehicle battery.
- This partial charge should be sufficient to start the vehicle.
- The PowerTank needs to be recharged after using as a starting aid.
WARNING: The Fuse and Switch is a function on the connect ( + ) ( - ) pole, current flows directly from the battery. Once
the jumper cables are connected, NEVER allow the cables to touch together or be left on the same metal surface, this will
result in short circuit and may start a fire.
WARNING: NEVER ATTEMPT TO START THE VEHICLE WITH THE POWER TANK CONNECTED.
SPECIFICATIONS
Internal Batteries: One Pcs. 12V/7Ah Rechargeable Sealed Lead-Acid Battery.
Operation Temp.: 32
°
F to 86
°
F / 0
°
C to 30
°
C
Model: #18774 – DC 12V Output D.C. 12V/10A protect with CIRCUIT BREAKER. Negative Ground.
DC 3,6,9V Output D.C. 3,6,9V. Fuse 2 Amp. Negative Ground.
Weight: 8.4 lbs. / 3.8 kg. (Approx.)
Dimension: 288 H x 236 W x 132 D / 11.3” x 9.3” x 5.2” (Approx.)
1. NO LED INDICATOR (LOW or CHARGE)
WHEN SWITCH IN ‘ON’ POSITION
2. NO LED INDICATOR (FULL or CHARGE)
WHEN RECHARGING.
3. DC-OUTPUT DOESN’T WORK.
WHEN SWITCH IN ‘ON’ POSITION
CIRCUIT BREAKER BREAKS THE CIRCUIT
CIRCUIT BREAKER BREAKS THE CIRCUIT
CIRCUIT BREAKER BREAKS THE CIRCUIT
RESET THE CIRCUIT BREAKER
ACCORDING TO THE INSTRUCTIONS
RESET THE CIRCUIT BREAKER
ACCORDING TO THE INSTRUCTIONS
RESET THE CIRCUIT BREAKER
ACCORDING TO THE INSTRUCTIONS
Copyright 2012 Celestron | All rights reserved.
(Products or instructions may change without notice or obligation).
This product is designed and intended for use by those 14 years of age and older.
2835 Columbia Street | Torrance, CA 90503 | TEL (310) 328-9560 | FAX (310) 212-5835 | www.celestron.com
PROBLEM POSSIBLE SOLUTION