GE - General Electric JM250DF1WW User Manual

Loading ...

49-80696 Rev. 4 15

%HVXUHWKHFRQWUROVDUHWXUQHGWR2))DQGWKHVXUIDFHXQLWVDUHFRROEHIRUHDWWHPSWLQJWRUHPRYHWKHP

Drip Pans

Remove the surface units. Then lift out the drip pans.

For best results, clean the drip pans by hand. Place them

LQDFRYHUHGFRQWDLQHURUDSODVWLFEDJZLWK»FXS

ammonia to loosen the soil. Rinse with clean water and

polish with a clean soft cloth.

The drip pans may also be cleaned in a dishwasher.

&OHDQWKHDUHDXQGHUWKHGULSSDQVRIWHQ%XLOWXSVRLO

especially grease, may catch fire.

'RQRWFRYHUWKHGULSSDQVZLWKIRLO8VLQJIRLOVRFORVHWR

the receptacle could cause shock, fire or damage to the

range.

NOTE: If your cooktop is equipped with shiny, silver-

colored drip pans, do not clean them in the self-cleaning

oven. Permanent damage to the finish can occur.

Lift-Up Cooktop

The entire cooktop may be lifted up and supported in the

up position for easier cleaning.

The surface units do not need to be removed; however,

you may remove one to make raising the cooktop easier.

There are two side supports that lock into position when

the cooktop is lifted up.

After cleaning under the cooktop with hot, mild soapy

ZDWHUDQGDFOHDQFORWKORZHUWKHFRRNWRS%HFDUHIXOQRW

to pinch your fingers.

To lower the cooktop, push the rods back and gently lower

the cooktop until it rests in place.

CARE AND CLEANING: Cleaning the Range – Exterior

Cleaning the Range – Exterior (Cont.)

Surface Units

To clean the surface units, turn the control to the highest

setting for a minute. The coils will burn off any soil.

To remove a surface unit:

To remove the drip pans for cleaning, the surface units

must be removed first.

/LIWWKHVXUIDFHXQLWDERXWLQFKDERYHWKHGULSSDQDQG

pull it out.

'RQRWOLIWWKHVXUIDFHXQLWPRUHWKDQLQFK,I\RXGRLW

may not lie flat on the drip pan when you plug it back in.

NOTE: Repeated lifting of the surface unit more than 1

inch above the drip pan can permanently damage the

receptacle.

To replace a surface unit:

1. Replace the drip pan into the recess in the cooktop.

Make sure the opening in the pan lines up with the

receptacle.

2. Insert the terminals of the surface unit through the

opening in the drip pan and into the receptacle.

3. Guide the surface unit into place so it rests evenly.

'RQRWLPPHUVHWKHVXUIDFHXQLWVLQOLTXLGVRIDQ\NLQG

'RQRWFOHDQWKHVXUIDFHXQLWVLQDGLVKZDVKHU

'RQRWEHQGWKHVXUIDFHXQLWSOXJWHUPLQDOV

'RQRWDWWHPSWWRFOHDQDGMXVWRULQDQ\ZD\UHSDLUWKH

plug-in receptacle.

Receptacle

'ULS3DQ

6XUIDFH8QLW

%HVXUHDOOVXUIDFHXQLWV

are turned off before

raising the Cooktop.

Support rod

Loading ...

GE JM250DF1WW 27" Drop-In Electric Range

User Manual - Page 15