Loading ...
Loading ...
Loading ...
4
GB
break out if the appliance is inadvertently
switched on.
No other use is permitted (e.g.heating
rooms).
INSTALLATION
The appliance must be handled and installed
by two or more persons. Use protective
gloves to unpack and install the appliance.
This appliance is intended to be used built-in.
Do not use it freestanding.
Installation and repairs must be carried out
by a qualied technician, in compliance with
the manufacturer’s instructions and local
safety regulations. Do not repair or replace
any part of the appliance unless specically
stated in the user manual.
Children should not perform installation
operations. Keep children away during
installation. Keep the packaging materials
(plastic bags, polystyrene parts, etc.) out of
reach of children, during and after the
installation.
After unpacking the appliance, make sure
that it has not been damaged during
transport. In the event of problems, contact
the dealer or your nearest After-sales Service.
The appliance must be disconnected from
the power supply before any installation
operation.
During installation, make sure the appliance
does not damage the power cable.
Only activate the appliance when the
installation has been completed.
After installation, the bottom of the
appliance must no longer be accessible.
Carry out all cabinet cutting works before
tting the appliance in the furniture and
carefully remove all wood chips and sawdust.
Do not obstruct the minimum gap between
the worktop and the upper edge of the oven.
Only remove the oven from its polystyrene
foam base at the time of installation.
Do not install the appliance behind a
decorative door - Risk of re.
After unpacking the appliance, make sure
that the appliance door closes properly.
In the event of problems, contact the dealer
or your nearest After-sales Service.
ELECTRICAL WARNINGS
For installation to comply with current safety
regulations, an omnipolar switch with
minimum contact gap of 3 mm is required
and the appliance must be earthed.
If the power cable is damaged, replace with
an identical one. The power cable must only
be replaced by a qualied technician in
compliance with the manufacturer
instruction and current safety regulations.
Contact an authorized service center.
It must be possible to disconnect the
appliance from the power supply by
unplugging it if plug is accessible, or by
means of an accessible multi-pole switch
installed upstream of the socket in
conformity with national electrical safety
standards.
The rating plate is on the front edge of the
oven (visible when the door is open).
In case of replacement of power cable,
contact an authorized service center.
If the tted plug is not suitable for your
socket outlet, contact a qualied technician.
The power cable must be long enough to
connect the appliance, once tted in its
housing, to the main power supply. Do not
pull the power supply cable.
Do not use extension leads, multiple sockets
or adapters.
Do not operate this appliance if it has a
damaged mains cord or plug, if it is not
working properly, or if it has been damaged
or dropped. Keep the cord away from hot
surfaces.
The electrical components must not be
accessible to the user after installation.
Do not touch the appliance with any wet part
of the body and do not operate it when
barefoot.
CLEANING AND MAINTENANCE
Never use steam cleaning equipment.
WARNING: Ensure that the appliance is
switched o before replacing the lamp to
avoid the possibility of electric shock.
Do not use harsh abrasive cleaners or sharp
metal scrapers to clean the appliance door
glass since they can scratch the surface,
which may result in shattering of the glass.
WARNING: It is hazardous for anyone other
than a competent person to carry out any
service or repair operation that involves the
removal of a cover which give protection
against exposure to microwave energy.
Failure to maintain the oven in a clean
condition could lead to deterioration of the
surface that could adversely aect the life of
Loading ...
Loading ...
Loading ...