Loading ...
Loading ...
Loading ...
9
Accessories
The following accessories are available to use with the Explorian model and other Vitamix Legacy blenders.
1. Personal Cup and Adapter
2. Tamper Holder
3. Blade Scraper
ap p e n d i x 1 - acc e S S o r i e S
Tamper Holder use and care insTrucTions
Note: When properly installed, the tamper
holder will not interfere with blender
operation. The tamper holder can be
installed on the left or right side of the
motor base.
1. Clean the parts by hand with warm,
soapy water or in the top rack in the
dishwasher before assembling.
2. Choose a side of the motor base to
install the tamper holder.
3. Lift up the blender base. Put the tamper
holder base onto the blender frame.
Lower the blender base back onto the
work surface or counter. Put the tamper
holder cup onto the tamper holder base.
Twist the tamper holder cup clockwise
to lock into place.
4. Make sure the blender is sitting flat and
Blade scraper use and care insTrucTions
1. Clean the parts by hand with warm, soapy water or in the top rack in the dishwasher before use.
2. Use the blade scraper to remove thick ingredients like jam and peanut butter from under the blades only after the container
has been removed from the motor base.
Keep hands and utensils out of container while blending to reduce the
risk of severe injury to persons or damage to the blender. A rubber
scraper, spatula or blade scraper may be used, but only when the blender
is not running and after the container has been removed from the motor
base.
Do not leave foreign objects, such as spoons, forks, knives, scrapers,
spatulas or the lid plug, in the container as this will damage the blades
and other components when starting the blender and may cause injury
.
IMPORTANT!
Proper installation
(flush against motor base)
steady (no rocking side to side) before blending. When installed properly, the inside flat surface of the tamper holder
cup will sit flush with the side of the blender (See photo).
5. Remove the tamper holder from the blender regularly to clean. To remove the tamper holder cup, rotate the cup
counter-clockwise.
6. To remove the base, lift up on the motor base and remove the tamper holder base.
Loading ...
Loading ...
Loading ...