INSTALLATION AND SERVICE MUST BE PERFORMED BY
A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
This conversion kit must be installed by a qualified service technician in accordance
with the manufacturer's instructions and all applicable codes and requirements of the authority
having jurisdiction. Failure to follow instructions may result in fire, explosion or production of carbon
monoxide causing property damage, personal injury or loss of life. The qualified service agency is
responsible for the proper installation of this kit. The installation is not proper and complete until the
operation of the converted appliance is checked as specified in the manufacturer's instructions
supplied with this kit.
[F_ Before proceeding with the conversion, shut off the gas supply before disconnecting
electrical power to the range. Be sure both power supplies are off before installing the conversion
kit. Failure to do so could cause serious bodily injury.
When burners are converted from Natural to LP the BTU rating is as follows:
9,000 BTU* Natural Gas to 8,000 BTU* LP Gas. The LP converstion kit contains:
P/N Part Description Notes
4 316470401
1 316417511
8,000* BTU LP Burner Orifices
LP Conversion Installation Instructions
marked 68L (.79mm orifice size)
*NOTE; For operation at elevations above 2000 ft.; appliance rating shall be reduced at the rate of 4 peicent for each 1000 if, above
sea level. After replacing the natural gas to LP orifices, be sure to keep the original factory installed natural gas orifices for future
range conversion back to natural gas:
Converting the appliance for use with LP/
Propane Gas
Tools Required"
1/2" Open End Wrench
5/8" Open End Wrench
1/4" Nutdriver
10mm Nutdriver
10mm Open End Wrench
or
1. Convert Pressure Regulator
Before proceeding with the conversion,
shut off the gas supply before disconnecting electrical
power to the range. Be sure both power supplies are
off before installing the conversion kit. Failure to do
so could cause serious bodily injury.
a. Lift and lock cooktop into raised position. Locate the gas
pressure regulator, The regulator islocated atthe right rear
of the burner box and is attached to the manifold pipe.
b. Unsnap the plastic dust cap protector from the brass
pressure regulator cap. Use a 5/8" open-end wrench to
loosen and then remove the brass pressure regulator cap
(See Fig. 1). DO NOT remove the spring from the
pressure regulator.
pin 316417511 (En/Fr) 0609
c. Turn the pressure regulator cap over so the hollow end
faces toward the regulator as illustrated (See Fig. 1).
Before installing the brass pressure regulator cap, be sure
to remove the dust protector and reinstall the ring portion
of the dust protector. The ring portion of the protector
MUST be installed. The ring portion of the dust protector
acts as a spacer between the regulator and brass
regulator cap when converted to LP.
d: Using a 5/8" open-end wrench tighten the pressure
regulator cap until snug.
e: Snap the dust protector back over the pressure regulator
cap.
HOLLOW END
PRESSURE
REGULATOR
CAP
TOWARDS _ _
REGULATOR _
FOR NATURAL GAS _"
SOLID END
TOWARDS
REGULATOR
FORLP. GAS
SPRING
Fig. 1
Loading ...
Loading ...
