Maytag GGE390LXS cooking

User Manual - Page 9

For GGE390LXS.

PDF File Manual, 20 pages, Download pdf file

Loading ...
Loading ...
Loading ...
9
4-wire connection: Power Supply Cord
Use this method for:
New branch-circuit installations (1996 NEC)
Mobile homes
Recreational vehicles
In an area where local codes prohibit grounding through
the neutral
1. Part of metal ground strap must be cut out and removed.
2. Use Phillips screwdriver to remove the ground-link screw
from the back of the range. Save the ground-link screw
and the end of the ground link under the screw.
3. Feed the power supply cord through the strain relief in the
cord/conduit plate on bottom of range. Allow enough slack
to easily attach the wiring to the terminal block.
4. Use Phillips screwdriver to connect the green ground wire
from the power supply cord to the range with the ground-link
screw. The ground wire must be attached first.
A
B
C
A. Metal ground strap
B. Discard
C. Ground-link screw
C
D
A. Terminal block
B. Ground-link screw
C. Cord/conduit plate
D. Power supply cord wires
5. Use
3
/
8
" nut driver to connect the neutral (white) wire to the
center terminal block post with one of the 10–32 hex nuts.
6. Connect line 1 (black) and line 2 (red) wires to the outer
terminal block posts with 10-32 hex nuts.
7. Securely tighten hex nuts.
NOTE: For power supply cord replacement, only use a
power cord rated at 250 volts minimum, 40 amps or 50 amps
that is marked for use with nominal 1
3
/
8
" (3.5 cm) diameter
connection opening, with ring terminals and marked for use
with ranges.
8. Replace terminal block access cover.
3-wire connection: Power Supply Cord
Use this method only if local codes permit connecting chassis
ground conductor to neutral wire of power supply cord.
1. Feed the power supply cord through the strain relief in the
cord/conduit plate on bottom of range. Allow enough slack
to easily attach the wiring to the terminal block.
A
B
C
F
D
E
D. Green ground wire
E. Neutral (center) wire
F. Line 2 (red)
A. 10–32 hex nut
B. Ground-link screw
C. Line 1 (black)
A
C
B
D
A. Terminal block
B. Ground-link screw
C. Cord/conduit plate
D. Power supply cord wires
Loading ...
Loading ...
Loading ...