Loading ...
Loading ...
Loading ...
10
1 2 3
4 5
1
2
2
1
1
1 2 3
4
9
876
5
10
2
clik
clik
2
1
Washing the brush bars
Lavado de los cepillos
Clearing brush bar obstructions
Eliminación de las obstrucciones del cepillo
SOFT ROLLER CLEANER HEAD INSTRUCTIONS
LOOKING FOR BLOCKAGES
• Ensure the machine is disconnected from the charger before looking for
blockages. Be careful not to pull the ‘ON’ trigger.
• Do not operate while checking for blockages as doing so could result in
personal injury.
• Beware of sharp objects when checking for blockages.
• To gain access to blockages in the floor tool, remove the base plate by using a
coin to loosen the screw marked with a padlock.
• If you cannot clear an obstruction you may need to remove the brush bars,
please refer to the 'Washing the brush bars' section for instructions on how to
do this. Remove the obstruction and replace the brush bars as shown in the
'Washing the brush bars' section. Ensure that the fastener is fully turned and the
brush bars are secure before operating the machine.
• This machine has carbon fiber brushes. Take care if coming into contact with
them, as they may cause minor skin irritation. Wash your hands after handling
the brushes.
• Refit all parts securely before using.
• Clearing blockages is not covered by your warranty.
WASHING THE BRUSH BARS
• Your machine has two washable brush bars, check and wash these regularly
according to the following instructions to maintain performance.
• Ensure the machine is disconnected from the charger before removing the brush
bar. Be careful not to pull the 'ON' trigger.
TO REMOVE, WASH AND REPLACE BRUSH BARS:
• Please refer to the 'Washing the brush bars' illustrations alongside the
instructions below.
• Turn the cleaner head upside down so the underside of the cleaner head is
facing you. Use a coin to turn the fastener one quarter counter-clockwise to the
unlocked position.
• Rotate the end cap to the open position. Gently slide the large brush bar away
from the cleaner head.
• Remove the end cap from the large brush bar.
• Lift out the small brush bar from the octagonal end and pull away from the
cleaner head.
• Hold the brush bars under running water and gently rub to remove any lint
or dirt.
• Stand both brush bars upright. Ensure the large brush bar is stood upright as
shown. Leave to dry completely for a minimum of 24 hours.
• Before replacing, check that the brush bars are completely dry. Refit the small
brush bar before the large one. Insert the round end of the small brush bar into
place. Push down the octagonal end until it clicks into place.
• Reattach the end cap to the brush bar.
• Slide the large brush bar back onto the cleaner head, around the motor.
The end cap should be in the open position as shown. Once in place, rotate the
end cap back into the closed position.
• Close the fastener by turning a quarter turn clockwise. Ensure that the fastener is
fully turned and the base plate and the brush bars are secure.
10/7/14 9:10 AM C67725_DYS_OPMAN_US_X480-SV06-ABSOLUTE-OPMAN-67725.indd_15_4c0s
Loading ...
Loading ...
Loading ...