Loading ...
Loading ...
Loading ...
5
LOCATION OF PARTS
INSTALLATION INSTRUCTIONS
• Remove the exterior and interior packing.
BEFORE USING YOUR APPLIANCE
• CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2 hours to
allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so
may adversely affect performance and the lifetime of this unit.
• Clean the interior surface with lukewarm water using a soft cloth.
• The appliance is designed for built-in or recessed or free standing installation for indoor or outdoor
use.
INSTALLATION OF YOUR APPLIANCE
• CAUTION: This appliance is not designed for the storage of medicine or other medical products.
• Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs.
• For free standing installation, 5 inches (127mm) of space between the back and sides of the unit and
4” at the top are suggested, which allows the proper air circulation to cool the compressor and
condenser. Even for built-in installation, it is a must to keep ¼” (6.35mm) space on each side and at
Door
(stainless steel
or glass)
Stainless steel
handle
Thermostat
and light switch
Glass shelves (3)
Evaporator
(behind rear wall)
Bottom grille
Adjustable feet (4)
Lock (not shown)
at top of door
Loading ...
Loading ...
Loading ...