Loading ...
Loading ...
Loading ...
9
Operation and Controls
WIRE SHELVES
NOTE: Do not cover any part of the wire shelves with aluminum foil or any other material that will prevent ade-
quate air circulation within the cabinet.
This appliance is equipped with slide-out removable shelves. To prevent damage to the door gasket, make
sure the door is opened completely before pulling the shelves out.
For easy access of the beverage cans, you must pull the shelves approximately ⅓ out of the railing.
The shelves are designed with an emergency stop to prevent them being removed too far when loaded.
When removing the shelves out of the railing, make sure to remove all items first.
To remove the shelves, pull the shelf forward until the notch aligns with the plastic post. Lift the shelf and
continue to pull the shelf forward until it is completely removed from the internal compartment.
NORMAL SOUNDS
The unit is cooled by a compressor. The compressor pumps coolant through the cooling system, producing op-
erating noise. Even when the compressor cuts out, noises caused by changes in temperature and pressure are
unavoidable. Operating noise will be most audible immediately after the compressor comes on. It becomes qui-
eter as the operating period continues.
The following noises are normal and occur from time to time:
Gurgling sound, caused by the refrigerant flowing through the appliance’s coils,
Humming noise made by the compressor. This noise can get louder for brief periods when the motor is
switching on.
Cracking/popping sounds, resulting from the materials contraction and expansion due to temperature varia-
tions,
Fan operating sound, to circulate the air within the beverage cabinet.
Unusual noise is normally the result of improper installation.
Where the unit is installed in open-plan kitchen or in partition walls, the level of operating noise will be heard
more acutely. However, this is due to the surrounding architecture and not to the unit.
NOTE: An individual’s perception of noise is directly linked to the environment in which the unit is located, as
well the specific type of models. Our appliances are in line with international standards for such appliance and in
line with the latest technical developments. Please remember that the noise of the compressor and the coolant
circulating in the system is unavoidable.
INSTALLING STAINLESS STEEL HANDLES
This appliance includes stainless steel handles that are not required
to operate this appliance. To install the handles please follow the be-
low instructions:
1. The gaskets are easily displaced by hand, no tools are necessary.
2. Use a flat-head screwdriver to remove the two pre-installed decora-
tive plugs from the back of doors. Some beverage refrigerators have
no decorative plugs.
3. Install the handles tightly as shown with two screws, lock washers
and flat washers provided. (DO NOT over tighten as this will cause
damage to the handles and stainless steel door frames).
4. Replace the door gaskets to its original position.
Loading ...
Loading ...
Loading ...