Loading ...
Loading ...
Loading ...
Page 6 of 7
compressor is shut down. Water from melted frost is collected by means of a water tray installed underneath
the evaporator at the upside of the unit. Periodically spill the defrost water in the water tray.
Frost should be removed from the freezer compartment once it reaches a thickness of over 3-4 mm. Never
use metal objects to remove the ice as it could damage the appliance.
Refrigerator Lamp
The central section of the thermostat box is fitted with a lamp for internal lighting. If replacement is required,
disconnect the appliance from the power supply, remove the protection grille from the thermostat unit and
unscrew the lamp. Replace with a lamp (10W max.) of the same voltage; refit the grille on the thermostat unit
to complete the replacement.
Prolonged periods of disuse
If you do not intend to use the appliance for long periods of time. Set the thermostat knob to the “OFF” or “0”
position and disconnect the power supply. Then take out the foods, defrost and clean the appliance. Leave the
door slightly open.
Cleaning the Appliance
Disconnect the power supply before cleaning the appliance.
Do not use coarse or aggressive cleaning agents as you may damage the surface.
Clean the exterior with cloth.
Remove the detachable accessories in the interior of the appliance and clean with water and liquid detergent.
Plastic parts cannot be washed in dishwashers.
Wash the interior of the appliance with wet cloth, adding one or two spoonfuls of vinegar.
After cleaning, connect the appliance to power supply and reload it.
TROUBLESHOOTING
Defective operation of the appliance is not always due to a technical fault but is often caused by incorrect
installation or use. To avoid unnecessary technical assistance and relative expenses we recommend the
following procedures.
1. Internal temperature is not cool enough
Check:
- make sure that the door closes properly;
- make sure that the thermostat setting is correct;
- make sure that the refrigerator is not positioned close to heat sources;
- make sure that air can circulate freely at the rear of the appliance;
- make sure that the condenser is not blocked.
2. Internal temperature is too low
Check:
-make sure that the thermostat setting is correct.
3. Excessive appliance noise level
Check:
- Make sure that the appliance is leveled correctly.
4. Appliance operation failure
Check:
-make sure that the thermostat is not set to “OFF” or “0”；
-make sure that the power supply is not disconnected；
-make sure that the plug is inserted correctly into the mains socket；
Loading ...