Loading ...
Loading ...
Loading ...
22
US
HT-RT3
4-587-771-13(3)
D:\NORM'S JOB\SONY HA\SO160016\HT-RT3 (PMRF
04)\4587771133_USCaFRLaES\US\070OTH.fm
masterpage: Left
Sound may be interrupted when the
sampling frequency or the number of
channels of audio output signals from
the playback equipment is switched.
If the connected equipment is not
compatible with copyright-protection
technology (HDCP), the image and/or
the sound from the HDMI OUT jack of
this system may be distorted or may
not be output. In such a case, check
the specifications of the connected
equipment.
Saving power in standby
mode
Check that you have made the following
settings:
“CTRL” in “HDMI>” is set to “OFF”
(page 18).
“BTSTB” in “BT >” is set to “OFF”
(page 18).
Mounting the Bar
Speaker and the
Surround Speakers on a
wall
You can mount the Bar Speaker and the
Surround Speakers on a wall.
Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely in the wall beam. Install the
speakers on a vertical and flat wall where
reinforcement is applied.
Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.
Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1 Prepare screws (not supplied) that
are suitable for the holes at the
rear of the Bar Speaker or
Surround Speakers.
2 Fasten the screws in the wall.
The screw should protrude as
illustration.
For the Bar Speaker
Notes
4 mm (
3
/
16
in)
More than 30 mm (1
3
/
16
in)
5 mm
(
7
/
32
in)
Hole at the rear of the speakers
9.5 mm
(
3
/
8
in)
600 mm (23
5
/
8
in)
6 mm to
7mm
(
1
/
4
in to
9
/
32
in)
Loading ...
Loading ...
Loading ...