Loading ...
Loading ...
Loading ...
Consumer SupportOperating InstructionsSafety Instructions
Installation
Instructions
Troubleshooting Tips
Cooktop Surface
To avoid damaging the stainless steel surface
of the cooktop and to prevent it from
becoming dull, clean up spills right away.
F
oods with a lot of acid (tomatoes,
sauerkraut, fruit juices, etc.) or foods with
high sugar content could cause a dull spot
if allowed to set.
When the surface has cooled, wash and
rinse. For other spills such as fat spatterings,
etc., wash with soap and water once the
surface has cooled. Then rinse and polish
with a dry cloth.
NOTE: Do not lift the cooktop. Lifting the
cooktop can lead to damage and improper
operation of the range.
N
OTE: Do not store flammable materials
in an oven, drawer or near the cooktop.
Do not store or use combustible materials,
gasoline or other flammable vapors and
liquids in the vicinity of this or any other
a
ppliance.
Oven Air Vents
Never block the vents (air openings) of the
range. They provide the air inlet and outlet
that are necessary for the range to operate
properly with correct combustion.
Air openings are located at the rear of
the cooktop, at the top and bottom of the
oven door, and at the bottom of the range,
under the lower cooking drawer.
Upper Control Panel
See the Gas/Control Lockout information in
the Special features of your oven control
section in this manual.
Clean up splatters with a damp cloth.
You may also use a glass cleaner.
Remove heavier soil with warm soapy water.
Do not use abrasives of any kind.
Unlock the touch pads after cleaning.
Vent appearance and location vary.
Lower Control Panel (Front Manifold Panel) and Knobs
It’s a good idea to wipe the control panel
after each use of the oven. Use a damp cloth
to clean or rinse. For cleaning, use mild soap
and water or a 50/50 solution of vinegar and
water. For rinsing, use clean water. Polish dry
with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven
cleaners on the control panel—they will
damage the finish.
Do not try to bend knobs by pulling them up
or down or by hanging a towel or other such
loads. This can damage the gas valve shaft.
The control knobs may be removed
for easier cleaning.
Make sure the knobs are in the OFF positions
and pull them straight off the stems for
cleaning.
The knobs can be cleaned in a dishwasher
or they may also be washed with soap and
water. Make sure the insides of the knobs are
dry before replacing.
Replace the knobs in the OFF position
to ensure proper placement.
Metal parts can be cleaned with soap and
water. Do not use steel wool, abrasives,
ammonia, acids or commercial oven
cleaners. Dry with a soft cloth.
NOTE: The lower oven drawer control knob is
not interchangeable with the surface burner
knobs. Be sure to reinstall the lower oven
drawer knob to the original location. The lower
oven drawer knob may be identified by the
increasing numbers from “WM” to “450.”
Surface burner knob
GEAppliances.com
35
Loading ...
Loading ...
Loading ...