AP45030H User Manual

Loading ...

Electrical Requirements

Electrical Connection

To properly install your air purifier, you must determine the type of

electrical connection you will be using and follow the instructions

provided for it here.

■ The air purifier should be connected to a 115 V, 60 Hz, 15- or

20-ampere fused 3 prong grounded outlet.

■ The use of a time-delay fuse or time-delay circuit breaker is

recommended.

Location Requirements

■ You will need a level surface at least 6 in. (15.2 cm) from heat

sources such as ranges or heaters.

■ Do not block the air openings or place the air purifier on a soft

surface such as a bed or sofa.

■ Operate indoors only.

AIR PURIFIER USE

Starting/Stopping Your Air Purifier

NOTE: Before operating the air purifier, record the date of

installation on the HEPA filter, which should be replaced annually.

The pre-filter should be replaced every 3 months. To remove and

replace either filter, see “Filter Replacement” in the “Air Purifier

Care” section.

1. Plug into a grounded 3 prong outlet.

NOTE: Both filter indicator lights will flash once during a self-

test when the air purifier is turned on or after a power

interruption.

2. Turn the fan speed knob to the large fan icon (High), the

middle fan icon (Medium) or the small fan icon (Low) to select

the desired fan speed.

3. Turn the fan speed knob to Off to turn the air purifier off.

1. 6 in. (15.2 cm) min. clearance

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Failure to follow these instructions can result in

death, fire, or electrical shock.

Do not use an extension cord.

Do not use an adapter.

Do not remove ground prong.

1. Low fan speed

2. Medium fan

speed

3. High fan speed

4. HEPA filter

indicator light

5. Pre-filter indicator

light

6. Filter Reset button

Change

HEPA Filter