Loading ...
Loading ...
Loading ...
32
WATER FILTER
WATER FILTER
It is recommended that you replace the water filter:
Approximately every six months.•
When the water filter indicator •
turns on.
When the water dispenser output •
decreases.
When the ice cubes are smaller •
than normal.
Rotate the water filter up into •
position and close the cover.
The cover will click when closed
correctly.
3. After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately 5 minutes)
to remove trapped air and contaminants from
the system. Do not dispense the entire 2.5 gallon
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
4. Water Filter Bypass Plug
Keep the water filter
bypass plug. You MUST
use the water filter
bypass plug when a
replacement water
filter cartridge is not
available.
CAUTION: DO NOT operate refrigerator without
water filter or water filter plug installed.
NOTE: To purchase a replacement filter, in the U.S.A.
call 1-844-553-6667, and in Canada 1-800-469-4663.
Replacement Filter: 04609690000P
1. Remove the old water filter.
Lower or remove the top left shelf •
to allow the water filter to rotate
all the way down.
Pinch the sides to open the •
water filter cover.
NOTE: Replacing the water filter
causes a small amount of water
(around 1 oz. or 25 cc) to drain. Place
a cup under the front end of the water
filter cover to collect any leaking water.
Hold the water filter upright, once it is
removed, to prevent any remaining water
from spilling out of the water filter.
Pull the water filter downward •
and pull out. Make sure to rotate
the filter down completely before
pulling it out of the manifold hole.
Before Replacing the Water Filter:
If the top shelf, located below the water filter, is in the
highest position, it will need to be removed prior to
replacing the water filter.
To remove any shelf–Tilt up the
front of the shelf
1
and lift it
2
.
Pull the shelf out.
2. Replace with a new water filter.
Take the new •
water filter out
of its packing
and remove the
protective cover
from the o-rings.
With water
filter tabs in the
horizontal position,
push the new
water filter into the
manifold hole until
it stops.
Water Filter
Bypass Plug
Loading ...
Loading ...
Loading ...