Loading ...
Loading ...
Check location where washer will be
installed. Proper installation is your
responsibility. Make sure you have
e
verything necessary for correct
installation.
Do Not store or operate washer below
32°F (0°C) (some water may remain in
washer).
Hot and cold water faucets: Must be
within 4 feet (1.2 meters) of the back
of the washer and provide water
p
ressure 10 - 100 PSI (69-690 kPa). A
pressure reduction valve should be
used in the supply line where inlet
pressure entering the building
exceeds 100 PSI (690 kPa) to avoid
damage to the washer mixing valve.
Grounded
e
lectrical outlet
is required. See
Electrical
requirements.
Single washer
installations require
1
2-inch (300 mm)
minimum risers to
provide an air
cushion and avoid
noise and damage
to valves.
Untape and
open washer
lid. Remove
packages and
hoses from
washer.
Water heater: Set to
deliver 120°F (49°C)
water to the washer.
Standpipe drain system: Needs a
two-inch (50 mm) minimum carry-
away capacity of 17 gallons (64.4
liters) per minute. Top of standpipe
must be at least 39 inches (990 mm)
high and no higher than 72 inches
(1.83 m) from bottom of washer.
Level floor: Maximum slope
under washer — 1 inch (25 mm).
Front access to the pump area is
available by removing 2 No. T20
Torx
®†
screws and then removing
the front panel.
IMPORTANT: Floor must be sturdy
enough to support loaded washer
weight of 315 pounds (143 Kg).
A floor drain should be
provided under the bulkhead.
Prefabricated bulkheads with
electrical outlets, water supply
lines and drain facilities should
be used only where local
codes permit.
IMPORTANT: Observe all governing
codes and ordinances.
PAGE 3
No. T20 TORX
®†
screws
†® TORX is a registered trademark of Acument
Intellectual Properties, LLC.
8315954 Rev B ENv06:YC10665/8315954A 5/3/10 11:04 AM Page 3
Loading ...
Loading ...
Loading ...