Loading ...
Loading ...
Loading ...
16
NOTE: Buttons are sensitive and should be touched gently. Avoid any grease or food particles
resting on the buttons as they could activate the dishwasher. Wiping and cleaning can also
activate the dishwasher. For best results, use bare, clean hands when touching the buttons.
WARNING
To avoid risk of injury, always use caution when opening the door during or following a wash cycle as
hot water or steam may escape. Do not fully open the door until water noises have stopped and steam
has subsided.
Start the Dishwasher
1
Press the [
On/Off]
button.
2 Select a cycle and desired options and press [Start].
Cancel a Cycle
1 Press and hold the [Start] button for approximately 3 seconds until the display reads “0:01”.
2 Wait about 1 minute while the dishwasher drains.
3 Press the [On/Off] button.
Interrupt a Cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button.
Setting the Amount of Rinse Aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1 Press the [On/Off] button.
2 Hold down the “A” button (see page 15) and press [Start] until the display indicates “H:0x”
(x can be any number).
3 Release both buttons.
4 Press the “A” button until the display shows “r:05”. NOTE: For models without a display, press the “A”
button until the LEDs for “Clean” and “Add Rinse Aid” are blinking.
5 Press the “C” button to select the desired setting.
“r:00” or 0 LEDs blinking = dispenser is OFF
“r:01” or 1 LED blinking = lowest setting
“r:02” = low setting
“r:03” or 2 LEDs blinking = medium setting
“r:04” = medium/high setting
“r:05” = high setting
“r:06” or 3 LEDs blinking = highest setting
6 Press [Start] to save the setting.
WARNING
Loading ...
Loading ...
Loading ...