Loading ...
Loading ...
Loading ...
11
To clean
1. Pull the lint screen straight up. Roll lint off the screen with your
fingers. Do not rinse or wash screen to remove lint. Wet lint is
hard to remove.
2. Push the lint screen firmly back into place.
IMPORTANT:
■ Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
■ If lint falls off the screen into the dryer during removal, check the
exhaust hood and remove the lint. See “Venting Requirements”
in the Installation Instructions.
As needed cleaning
Laundry detergent and fabric softener residue can build up on the
lint screen. This buildup can cause longer drying times for your
clothes, or cause the dryer to stop before your load is completely dry.
The screen is probably clogged if lint falls off while the screen is in
the dryer.
Clean the lint screen with a nylon brush every 6 months, or more
frequently
, if it becomes clogged due to a residue buildup.
To wash
1. Roll lint off the screen with y
our fingers.
2. W
et both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub
lint screen with the brush to remove residue buildup.
4. Rinse screen with hot water.
5. T
horoughly dry lint screen with a clean towel. Replace screen in
dryer.
Cleaning the Dryer Interior
To clean dryer drum
1. Make a paste with powdered laundry detergent and very warm
water.
2. Apply paste to
a soft cloth.
OR
Apply a liquid, nonflammable house
hold cleaner to the stained
area and rub with a soft cloth until all excess dye and stains are
removed.
3. W
ipe drum thoroughly with a damp cloth.
4. Tumble a load of clean cloths or towels to dry drum.
NOTE: Ga
rments that contain unstable dyes, such as denim blue
jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will not stain
future loads of clothes. Dry unstable dye items inside out to avoid
transfer of dye.
Removing Accumulated Lint
From Inside the Dryer Cabinet
Lint should be removed every 2 years, or more often, depending on
dryer usage. Cleaning should be done by a qualified person.
From the Exhaust Vent
Lint should be removed every 2 years, or more often, depending on
dryer usage.
Vacation, Storage, and Moving Care
Install and store your dryer where it will not freeze. Because some
water may stay in the hoses, freezing can damage your dryer. If
storing or moving your dryer during freezing weather, winterize it.
Non-Use or Vacation Care
Operate your dryer only when you are at home. If you will be on
vacation or not using your dryer for an extended period of time, you
should:
1. Un
plug dryer or disconnect power.
2. Gas models only: Close shutoff valve in gas supply line.
3. Clean lint sc
reen. See “Cleaning the Lint Screen.”
4. T
urn off the water supply to the dryer. This helps to avoid
unintended flooding (due to a water pressure surge) while you
are away.
Moving care
For power supply cord-connected dryers:
1. Unplug the power supply cord.
2. Gas models only: Close shutoff valve in gas supply line.
3. Gas models only: Disconnect gas supply line pipe and remove
fittings attached to dryer pipe.
4. Gas model
s only: Cap the open fuel supply line.
5. Steam model
s only: Shut off water faucet.
6. Steam models only: Disconnect the water inlet hose from faucet,
then drain the hose. Remove the hose from the back of the dryer.
Transport hose separately.
7. Ma
ke sure leveling legs are secure in dryer base.
8. Use tape to secure dryer door.
For direct-wired dryers:
1. Turn off power at fuse or breaker box.
2. Disconnect wiring.
3. Steam models only: Shut off water faucet.
Loading ...
Loading ...
Loading ...