Loading ...
Loading ...
Loading ...
E142551
3. Block both directions of the wheel that
is diagonally opposite to the wheel that
is being lifted.
4. Remove the spare tire and jack from
the storage location.
5. Remove the wheel trim (if equipped)
by inserting the tapered end of the lug
nut wrench behind the wheel cover or
hubcap and twist it off.
6. Loosen each wheel lug nut one-half
turn counterclockwise, but do not
remove them until the wheel is raise
off the ground.
Jacking location
E201348
Front axle jacking point: Place the jack
under the pin on the front surface of the
front axle.
Note: Do not place the jack under or on the
steering linkage.
E201346
Rear axle jacking points: All models except
E-350 and E-450 dual rear wheel.
E201347
Rear axle jacking points: E-350 and E-450
dual rear wheel.
Installing the spare wheel and tire
1. Refer to the diagrams above to locate
the correct jacking point for your
vehicle.
2. Raise the vehicle by using the jack
handle to turn the jack nut clockwise.
Once the flat tire is raised above the
ground, remove the lug nuts with the
lug wrench.
3. Replace the flat tire with the spare tire,
making sure the valve stem is facing
outward. Reinstall the lug nuts until the
wheel is snug against the hub. Do not
fully tighten the lug nuts until the wheel
has been lowered.
193
E-Series (TE4) Canada/United States of America, enUSA, Edition date: 201804, First-Printing
Wheels and Tires
Loading ...
Loading ...
Loading ...