Loading ...
Loading ...
Loading ...
aus Operating the appliance
24
1 Operating the
appliance
Oper at i ng the appl i anc e
AquaSensor *
AquaSensor
* depending on the features of your
dishwasher
The Aqua sensor is an optical
measuring device (light barrier) which
measures the turbidity of the rinsing
water.
The AquaSensor is used according
to the programme. If the AquaSensor is
active, “clean” rinsing water can be
transferred to the next rinse bath and
water consumption can be reduced by
3–6 litres. If the turbidity is greater,
the water is drained and is replaced
with fresh water. In the automatic
programmes the temperature
and running time can also be adjusted
to the degree of soiling.
Switching on the appliance
1. Turn tap fully on.
2. Switch on ON/OFF switch (.
The displays for the last programme
and last additional function selected
flash. These settings will be retained
unless another 0 programme key
is pressed. The expected
programme duration flashes on the
digital display `.
3. Press the START button X.
Programme sequence starts.
timeLight (optical display
while a programme
is running) *
timeLi ght
* depending on the configuration of
your specific dishwasher
While a programme is running, an
optical display (additional programme
information) is projected onto the floor
at the bottom of the appliance door. If
the base panel is pulled forwards or if
the appliance is installed at eye-level
flush with the furniture then this display
will not be visible.
Possible settings of the optical
display:
The setting †:‹‚ is set up at the factory.
Here’s how to change the setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button X until š:‹...
appears in the display window `.
3. Release both buttons.
The illuminated display on the button
# flashes.
4. Press the programme button #
repeatedly until †:‹... appears in the
display window `. (for the optical
display) together with the previously
set value, for example †:‹‚.
5. Press the programme button 3
repeatedly until the desired value, for
example †:‹‹, appears in the
display window `.
6. Press START button X.
The set value is saved.
†:‹‹ The display is switched off.
†:‹‚
/
†:‹ƒ
The display can show the
programme, the timed delay,
remaining time and end of the
programme.
Loading ...
Loading ...
Loading ...