Loading ...
Loading ...
Loading ...
10
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED TIME
TO CYCLE
ADDED
WATER
GALLONS
(LITERS)
Only sanitizing cycles have been designed to
meet the requirements of the NSF/ANSI 184
performance standard for soil removal and for
sanitization efficacy. There is no intention, either
directly or indirectly, that all cycles on a NSF/
ANSI 184 certified dishwasher meet the NSF/ANSI
184 performance standard for soil removal and
for sanitization efficacy. The Sani Rinse indicator
glows at the end of the cycle if the Sani Rinse
option was successfully completed. If your load
did not properly sanitize, the indicator light will
flash at the end of the cycle. This can happen if
cycle is interrupted or if the water does not reach
the required temperature. The light goes off when
you open and close the door or press CANCEL.
Auto
PowerBlast
®
Normal
Raises the main
wash temperate
to 145°F (62.8 °C)
and the final rinse
temperature to
(156°F (69 °C).
0:15 to 1:30 0 – 3.7
(0 – 14.0)
Dries dishes with heat. Use option with rinse aid to
provide best drying results. Plastic items are less
likely to deform when loaded in top rack. Use Heat
Dry for optimum drying performance.Turn option
off for an air dry.
Auto
PowerBlast
®
Normal
Quick
Uses a heating
element to speed
drying times. Heat
Dry option defaults
to On when any
cycle is selected
except for Quick
and Rinse.
0:11 to 0:46
Runs dishwasher at a later time or during off-peak
electrical hours. Select a wash cycle and options.
Press DELAY to cycle through the delay time
options. Close door firmly. Press START.
NOTE: Anytime the door is opened (such as, to
add a dish), the START keypad must be touched
again to resume the delay countdown.
Available
with any
cycle
Delays start of a
cycle by 4 hours.
Use the Control Lock option to avoid unintended
use of dishwasher between cycles and/or during
cycles.
To turn on Control Lock, press and hold
CONTROL LOCK for 3 seconds. Control Lock
light will stay on for a short time, indicating that
it is activated. When the Lock indicator is lit, all
buttons are disabled. If you press any button
while your dishwasher is locked, the light flashes
3 times. The dishwasher door can still be opened
closed while the controls are locked.
To turn off Control Lock, press and hold
CONTROL LOCK for 3 seconds. Control Lock light
turns off.
Hold 3 Sec
CONTROL PURPOSE COMMENTS
Press to START or a wash cycle If the door is opened during a cycle or the power is interrupted, the START
button light flashes. Cycle will not resume until door is closed and START is
pressed.
Press to cancel wash cycle Close the door firmly. Press and hold CANCEL for 3 seconds. The
dishwasher starts a 2-minute drain (if needed). Let dishwasher drain
completely.
The Add Dish indicator lets you
know that you may still open the
door and add a dish to the load.
If you open the door to add a dish you must close the door and press the
START keypad to resume the cycle.
The display allows you to follow
the progress of the dishwasher
cycle.
Models without a numeric display have indicators that glow for Add Dish,
Washing, Drying, Clean & Sanitized.
When cycle is finished, the
“Sanitized” indicator glows.
If your dishwasher did not properly sanitize your dishes, the light flashes
at the end of the cycle. This can happen if the cycle is interrupted or water
could not be heated to required temperature. The light goes off when you
open and close door or press Cancel.
CONTROLS AND CYCLE STATUS
Hold 3 Sec
Loading ...
Loading ...
Loading ...