Loading ...
Loading ...
Loading ...
Operating Instructions
46
Safety InstructionsInstallation Instructions
Troubleshooting TipsConsumer Support
Read these instructions completely and carefully.
Installation of the range.
3-Wire Conduit Installation Option
Remove the bracket with a 1
3
8 diameter
opening from the rear of the range and
retain the screws.
Locate the bracket with a 1
1
8 diameter
opening and the ground strap in the
installation accessory pack (packed with
the oven shelves on new ranges).
Install the new bracket to the rear of the
range, below the terminal block, using the
screws removed above.
Insert the ground strap under the neutral
terminal on the connector block. Connect
the other end of the ground strap to the
grounding plate using the ground screw.
Insert the conduit through the strain relief
and tighten. Allow enough slack to easily
attach the cord terminals to the connector
block. If tabs are present at the end of the
winged strain relief, they can be removed
for better fit.
NOTE: Do not install the conduit without a strain
relief. The strain relief bracket should be installed
before reinstalling the rear range wiring cover.
Insert bare wires between the connector
block terminals and movable nuts. Tighten
screws securely. Do not remove ground strap
connection.
Wire used, location and enclosure of splices,
etc., must conform to good wiring practices
and local codes.
Bare wire tips
Conduit
Connector block
Bracket
Screw
Flexible cable
Bare wire
Movable nut
Connector block
terminal
WARNING: Connector block is approved
for copper wire connection only. If aluminum wire is
used, see note below.
NOTE: ALUMINUM WIRING
Do not connect aluminum wire to the
connector block. Use copper building
wire rated for the correct amperage
and voltage to make three 3 copper
jumper wires.
Splice copper wires to aluminum
wiring using special connector
terminals designed and UL-approved
for joining copper to aluminum and
follow the connector manufacturer’s
recommended procedure closely.
Ground Strap
Bracket
1
1
8 dia. opening
Ground screw
Ground strap
Loading ...
Loading ...
Loading ...