Loading ...
Loading ...
Loading ...
CUSTOM PROGRAM
If you have a special combination of settings that
you use frequently, you can save these settings
as a CUSTOM PROGRAM.
*
To Save a Custom Program:
Turn on the dryer and turn the cycle selector
knob to select the desired cycle.
Use the cycle setting buttons to adjust the
settings for that cycle.
Press the cycle option button(s) for the option
you would like to add. A confirmation message
will be shown in the display.
Press and hold the CUSTOM PROGRAM button
for 3 seconds.
1
2
3
4
To Recall a Custom Program:
Turn on the dryer.
Press the CUSTOM PROGRAM button.
Press the START/PAUSE button to start
the cycle.
1
2
3
NOTE: You may only save one custom
program at a time. Pressing and holding the
CUSTOM PROGRAM button will overwrite
any previously saved custom program.
MAX
STEAM FUNCTIONS
1
2
3
4
To Fill the Steam Feeder
Pull out the drawer.
Lift out the steam feeder.
Fill the steam feeder to MAX with water.
Place the steam feeder in the drawer; then
push in the drawer until it clicks into place.
Water
ONLY
Steam
Feeder
Drawer
wWARNING:
•Donotfillthesteamfeederwithliquidssuchasgasoline,dry-cleaningsolvents,orotherflammableorexplosive
substances. They give off vapors that could explode.
•Donotfillthesteamfeederwithhotwater(over86°F/30°C).
•Donotdrinkwaterfromthesteamfeeder.
IMPORTANT NOTES ABOUT STEAM CYCLES
Before using a Steam Cycle, the steam feeder must be filled with water up to the MAX line. If not, the ADD
WATER light will blink. Make sure that the steam feeder is filled with water and the drawer is completely
closed. Turn the dryer off then restart the Steam Cycle.
•Onlyusewater.Donotfillthesteamfeederwithforeignsubstances,rinseagents,ordetergents.
•Beforemovingthedryer,makesurethesteamfeeder is empty.
•Donotusedistilledwater;thewaterlevelsensorinthesteamgeneratorwillnotwork.
•Be careful to put the Steam Feeder otherwise water will be overflow.
•WipeupanyspilledwateraroundtheSteamFeederandthedrawerbeforestartingthedryer.
32
Loading ...
Loading ...
Loading ...