Loading ...
Loading ...
Loading ...
19
Complete Installation (Propane Gas to Natural Gas)
1. Refer to the “Make Gas Connection” section for proper
connection of the range to the gas supply.
2. Refer to the “Electronic Ignition System” section for proper
burner ignition and operation.
3. Refer to the “Adjust Flame Height” section for burner ame
adjustments.
IMPORTANT: You may have to adjust the low setting for
each cooktop burner.
Checking for proper cooktop, bake, and broil burner ame is
very important. Natural gas ames do not have yellow tips.
4. Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
Adjust Flame Height
Adjust Surface Burner Flame
Adjust the height of top burner ames. The cooktop “low” burner
ame should be a steady blue ame approximately ¼" (6.3 mm)
high. Propane gas ames have a slightly yellow tip.
To Adjust Standard Burner:
The ame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
IMPORTANT: Make sure to save the orifices that have
just been replaced in the conversion.
A. Low ame
B. High ame
A
B
If the “Low” Flame Needs to Be Adjusted:
1. Light 1 burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small atblade
screwdriver to turn the screw located in the center of the
control knob stem until the ame is the proper size. Turning
the screw clockwise will increase the ame size and
counterclockwise will decrease the ame size.
3. Replace the control knob.
4. Test the ame by turning the control from the low position to
the high position, checking the ame at each setting.
5. Repeat the previous steps for each burner.
To Adjust Double Burner (On Some Models):
1. Light burner and turn to lowest setting where both inner and
outer burners are lit.
2. Remove the control knob.
3. Insert a 1/8" (3 mm) at-blade screwdriver into the
adjustment locations shown in the following illustration and
engage the slotted screw. Turn the screw until the ame is
the proper size. Turning the screw clockwise will increase the
ame size and counterclockwise will decrease the ame size.
4. Replace the control knob.
5. Test the ame by turning the control from the low position to
the high position, checking the ame at each setting.
Check Operation of Oven Bake Burner
Refer to the User Guide for proper operation of the oven controls.
A
B
C
A. Control knob stem
B. Screwdriver
C. Pliers
A
B
C
A. Control knob stem
B. Screwdriver
C. Pliers
Loading ...
Loading ...
Loading ...